[zeromq-dev] Libev integration problem: Stop receiving ZMQ_EVENTS events
Justin Karneges
justin at affinix.com
Mon Dec 10 18:37:06 CET 2012
I'm not sure if this is the issue you're having, but be aware that you have to
check ZMQ_EVENTS in *three* scenarios: after zmq_send, after zmq_recv, and
when ZMQ_FD triggers a read event.
On Monday, December 10, 2012 04:39:22 PM CheYi Lin wrote:
> I'm using the low level API "zmq.h" in C, integrating zmq with libev
> event-loop. My program is complicated but the zmq & libev integration part
> is
> simple. (http://pastebin.com/6JiSh46N)
>
> Sorry I'm new to the community.
> Best Regards,
> Cheyi Lin
>
> On Mon, Dec 10, 2012 at 4:13 PM, Pieter Hintjens <pieterh at gmail.com> wrote:
> > Can you make a raw test case (ideally in c using the low level API or
> > czmq)?>
> > On Dec 10, 2012 8:37 AM, "CheYi Lin" <cheyi.lin at gmail.com> wrote:
> >> Hi,
> >>
> >> I'm doing some zmq ROUTER-to-ROUTER experiments in my distributed
> >> system prototype.
> >> (single threaded, libev event loop based application)
> >>
> >> Below is my test steps:
> >>
> >> 1. ROUTER A and B start, set unique identity, bind the address.
> >>
> >> (handshake)
> >> 2. A connect to B.
> >> 3. A send HELLO to B continuously.
> >> 4. B recv HELLO then send HELLO_ACK back to A.
> >> 5. A recv HELLO_ACK and stop sending HELLO, handshake finished.
> >>
> >> (start communication)
> >> 6. A and B send HEARTBEAT to each other every 0.5 seconds.
> >> 7. When HEARTBEAT received, A and B print "recv HEARTBEAT".
> >>
> >> After about 30 seconds, A stop printing "recv HEARTBEAT" but B
> >> continue printing "recv HEARTBEAT".
> >> And few seconds later I terminate B, suddenly A print lots of "recv
> >> HEARTBEAT".
> >>
> >> I notice that A stop being signaled from the ZMQ_FD (in gdb), so all
> >> HEARTBEAT from B was queued
> >> after A stop printing "recv HEARTBEAT".
> >>
> >> My zmq-event handler:
> >> http://pastebin.com/6JiSh46N
> >>
> >> Don't know why the handler stop receiving ZMQ_EVENTS events.
> >> Could someone please review my code and give me some suggestions?
> >>
> >> Sorry for my bad english.
> >>
> >>
> >> Regards,
> >> Cheyi
> >> _______________________________________________
> >> zeromq-dev mailing list
> >> zeromq-dev at lists.zeromq.org
> >> http://lists.zeromq.org/mailman/listinfo/zeromq-dev
> >
> > _______________________________________________
> > zeromq-dev mailing list
> > zeromq-dev at lists.zeromq.org
> > http://lists.zeromq.org/mailman/listinfo/zeromq-dev
>
> _______________________________________________
> zeromq-dev mailing list
> zeromq-dev at lists.zeromq.org
> http://lists.zeromq.org/mailman/listinfo/zeromq-dev
More information about the zeromq-dev
mailing list