[zeromq-dev] Publish/subscribe example "Operation not supported by device"

Michael Glaesemann grzm at seespotcode.net
Tue Apr 6 07:30:26 CEST 2010


On Apr 6, 2010, at 1:19 , Martin Sustrik wrote:

> Michael Glaesemann wrote:
> 
>> Using s.bind ("tcp://127.0.0.1:5555"); instead of s.bind
>> ("tcp://lo:5555"); worked. Thanks! As far as eth0/en0 are concerned,
>> those aren't specified explicitly in the Publish/Subscribe example:
>> is this part of the jzmq bindings?
> 
> No. It's a specific to the operating system.
> 
> 0MQ documentation puts it this way: "Interface names are not 
> standardised in any way and should be assumed to be arbitrary and 
> platform dependent. On Win32 platforms no short interface names exist, 
> thus only the primary IPv4 address may be used to specify an interface."

Cheers. I'm working my way through the documentation and hadn't gotten there yet. Perhaps the examples should be updated to use IPv4 addresses?

Thanks again for your help!

Michael Glaesemann
grzm seespotcode net






More information about the zeromq-dev mailing list